Skip to content
XCell Roofing

Norfolk

Roof repairs in King's Lynn

Leaks, slipped tiles and failed lead put right across PE30, PE31 and PE34.

Repairs in Lynn split fairly neatly. On the older property in and around the centre it is nearly always leadwork or pointing that has given up. On the post war estates it is wind damage at the verge and ridge, and slipped tiles where the original clips were never quite right.

Older property

Lead that has had its day

Original lead around chimneys, parapets and abutments cracks along the fold lines with age and thermal movement. Sealant over it is a holding measure, not a repair. We strip it out and form new lead to code.

Parapet and hidden gutters

A lot of the older Lynn buildings have parapet walls with a concealed gutter behind them. When those block or split, water goes straight into the structure and it is often well advanced before anyone sees a stain.

Soft mortar and hard repairs

Historic brickwork wants a lime mortar. Repointing it in modern cement is harder than the brick, traps moisture and spalls the face off over the following winters. We use the right mix.

Estate property

Verges bedded in mortar crack and let wind under the tiles, and once one goes the row follows. Ridge tiles come loose the same way. Both are worth converting to a dry system when they are repaired rather than re-bedding them to fail again on the same timescale.

What you get from us

We trace the leak to its source rather than to the nearest stain, we photograph everything before and after, and if the roof is past repairing we will say so instead of selling you a patch that will not hold.

We trace the real source, not the nearest stain
Photographs before and after on every repair
Honest call on repair versus replacement
Storm damage reports written for insurers
Fully insured with a written workmanship guarantee

Roof repairs in King's Lynn: common questions

There is damp on my chimney breast but no drip. Is that the roof?

Very often it is the flashing where the stack passes through the roof. Water gets into the brickwork or runs behind failed lead and shows on the plaster rather than dropping. It rarely improves on its own.

Why does my mortar keep cracking on the verge?

Because mortar is rigid and the roof is not. Every re-bedding buys a few years. A dry verge system clamps the tiles mechanically and does not have the same failure mode.

Do you do emergency call outs in Lynn?

We will get to an active leak as quickly as we can and make it safe where the weather allows, then come back to do the permanent repair properly.

Ready to get started?

Tell us about your project and we'll be in touch.

Call now Get a quote