Flat roofing

Flat roofs got their bad reputation from felt that was never going to last. The systems we fit now are a different thing entirely, laid in one piece with no joins to open up, and they will outlast the extension underneath them.

Systems we install

GRP fibreglass

Laid wet and cured into a single sheet with no joins or welds anywhere in it. Hard wearing, walkable, and a good choice for balconies and dormers as well as extensions.

Single ply membrane

A tough sheet membrane, hot air welded at the laps, that copes well with larger areas and complex shapes. It goes down quickly and it does not need heat on the deck.

Torch on felt

Modern high performance felt in layers, a long way from the single layer that used to blister and split. Still the sensible answer on some garages and outbuildings.

Warm roof build ups

Insulation above the deck rather than below it keeps the structure warm and stops condensation forming inside the roof. It is what current building regulations expect on a habitable room.

Our process

1. Check the deck. We strip back and look at the boards. Covering a soft deck is the most common way a flat roof fails twice.
2. Get the falls right. Standing water is what kills flat roofs. We build in the fall so the roof actually drains.
3. Lay the system. Trims, upstands and outlets done properly, because that is where flat roofs leak.
4. Finish and guarantee. Edge detail, drainage checked with water, and your written guarantee.

Standards

We install to the manufacturer's specification, which is what keeps their material guarantee valid alongside our workmanship one. Where a roof needs to meet building regulations for insulation, we build it to do that and tell you what it involves before you commit.